Hirobo HI2506056 6 x 10 x 0.5 mm Stainless Flat Washer for RC Models  [HI2506056]

Thin stainless flat washer for RC assemblies

This Hirobo flat washer is an RC-scale replacement part sized 6 x 10 x 0.5 mm and made from stainless steel (SUS). It is intended as a thin flat washer for general RC assemblies where minimal thickness and corrosion resistance are required, such as model helicopter and small aircraft fastenings.

Role in assembly: used to distribute load from a screw or nut, maintain clearance, and act as a thin spacer where 0.5 mm thickness is sufficient. As an RC accessory, it helps preserve alignment and reduces local stress on soft or thin components during routine maintenance and tuning.

Installation notes: verify bore diameter and stack height before fitting, install flat against the mating surface, and check for proper torque on fasteners to avoid deformation. Because this is an RC-scale stainless steel washer, it is suitable for repeated small-scale servicing without implying any full-size vehicle application.