Hirobo HI2506025 Flat Washer 8 x 15.5 x 1.6 mm for RC Helicopter Hardware  [HI2506025]

Precision flat washer for RC helicopter assemblies

This RC flat washer is listed as Hirobo part HI2506025 and shown as 8 x 15.5 x 1.6 for identification. It is intended as a general-purpose hardware item for helicopter spare-part inventories where a thin spacer and a flat bearing surface are required in compact assemblies.

In use the washer serves as a spacer and spreads load between fastener heads and mating parts, helping to stabilise preload and reduce wear on softer components. Store this item with routine maintenance spares for small repairs and light rebuilds when an exact-fit washer is needed.

Installation notes: check that the inner and outer diameters match the bolt and seating geometry before reuse, fit the washer flat to the mating surface, and replace it if any bending or corrosion is evident. This description covers RC helicopter applications only and does not imply suitability for other non-model uses.