Hirobo HI0414131 Right Elevator Lever Shaft for Freya Helicopters  [HI0414131]

Right elevator lever shaft R details

This replacement elevator lever shaft R is a direct-fit replacement listed for the Hirobo Freya line, provided as a single right-side shaft to restore correct elevator linkage alignment on the helicopter tail assembly. It is presented as an RC-scale accessory intended for maintenance and repair of control linkages.

Installation notes: confirm right-side orientation before fitting, remove any worn fasteners and inspect the mating lever for play, slide the shaft into position and ensure smooth pivoting across its range of motion, then secure the retaining hardware and verify full elevator throw without binding. After installation, perform ground checks at low throttle to confirm neutral alignment and control response.

Tuning role: replacing a worn or bent elevator lever shaft helps restore crisp elevator input and reduces play that can affect trim and cyclic balance, making small linkage improvements useful when diagnosing persistent control slop.