Hirobo HI0404620 Eagle Elevator Lever Rod Set for Eagle/Freya/EX/SX  [HI0404620]

HIROBO 0404-620 EAGLE ELEVATOR LEVER ROD SET #0404620
Price:
CAD$15.63
Brand:
Hirobo
Model:
HI0404620
GTIN:
4512895108618
Condition:
Brand New
Write a review

Hirobo Eagle Elevator Linkage Rods

This Hirobo HI0404620 elevator lever rod set is a direct replacement part for the elevator linkage on Hirobo Eagle series helicopters. It is intended for routine service and small repairs, restoring the connection between cyclic/servo outputs and the tail/elevator mechanism.

During fitting, inspect each rod for straightness, confirm free movement at the ball ends, and ensure correct thread engagement before flight. Replacing worn linkage restores geometry and reduces play, keeping pitch input predictable during hover and basic aerobatics.

Compatibility

  • Eagle
  • Freya
  • EX
  • SX

Are these rods a straight swap for the original elevator linkages?

They are supplied as a standard replacement for the Eagle series. Always compare thread sizes and overall length with your existing parts to confirm a direct fit before tightening set screws.

Which tools will I need to install these rods?

Basic hand tools plus a small hex driver for the set screws are normally sufficient. Keep a pair of needle-nose pliers and a thread locker handy for secure assembly.

What checks should I run after replacing the elevator rods?

Set elevator neutral, cycle full travel to check for binding, and perform a low-throttle ground hover to confirm the control response and trim stability before any full-power flight.

Copyright © 2008-2026 rcjaz.ca All rights reserved