Hatroi HA221 Compact Wire Holders for 4-Cycle RC Engines  [HA221]

Compact wire holders for 4-cycle RC engines

Hatroi HA221 wire holders are compact routing clips designed to keep ignition leads and accessory wiring tidy on 4-cycle RC engines. They create a low-profile route so wires are less likely to snag nearby components during setup and running.

The clips suit inline wiring runs common in scale 4-cycle installations and accept single conductors or small bundled runs. To install, position the holder on the planned cable path, press the wire into the snap-fit clip, and re-check the routing after a short test run.

For tuning and workshop work the HA221 keeps wiring consistent so sensors and ignition leads remain clear of moving parts and away from likely abrasion points. Use these holders to simplify fault finding and reduce intermittent faults caused by loose or chafed wiring.