GTXE Carbon Center Mounting Plate for Flat Chassis - 354253 XRAY  [XR-354253]

XRAY 354253 - GTXE Carbon Center Mounting Plate - Flat Chassis
Price:
CAD$60.08
Brand:
XRAY
Model:
XR-354253
Condition:
Brand New
Write a review

GTXE centre top deck overview

This centre top deck is an RC carbon centre mounting plate made for the GTXE flat chassis layout, designed to alter mid-section stiffness and affect how chassis flex is distributed around the drivetrain area. The plate is precision machined from carbon fiber to provide a measured balance of rigidity and low weight suited to competitive track setups.

The part is intended for setup and tuning: increasing centre stiffness modifies chassis response during weight transfer and under drivetrain load, helping drivers tune front-to-rear balance without changing suspension geometry. As a structural top deck, its true effects are best judged as part of a complete chassis setup rather than in isolation.

Specifications

  • Item: Center mounting plate
  • Material: Carbon fiber
  • Model Number: 354253
  • Compatibility: GTXE flat chassis

Confirm alignment with the GTXE centre mounting points before final assembly and introduce stiffness changes gradually, logging each adjustment so handling trends are clear.
Remark :
Due to limited stock availability, please notice that some XRAY items may have to order from the factory and the ready time is around 4-6 weeks. Customer purchases the item is assumed to accept the waiting time which allows us to order directly from the manufacturer if the item is out of our warehouse.

How do I check fitment on my GTXE?

Visually align the plate to the existing centre screw locations on your GTXE flat chassis before tightening. Trial-fit with original hardware to confirm hole spacing and clearance for drivetrain components.

What handling changes should I expect?

Expect a firmer mid-section that often improves mid-corner stability and consistency; however, you may need to soften shock or alter anti-roll distribution to regain the preferred balance.

Can I use the plate with existing screws?

Yes, the plate is machined to standard GTXE mounting patterns so existing centre hardware is normally reusable; always check thread engagement and replace any worn fasteners.

How do I maintain a carbon centre plate?

Inspect after heavy sessions for surface cracks or delamination, clean debris away with a soft brush and avoid aggressive solvents. Replace the plate if structural damage is visible.

Should I change other setup items after fitting this plate?

Yes. Start by testing small changes to shock damping and roll bar settings, then record lap times and handling notes to understand how the stiffer centre deck impacts overall balance.

Copyright © 2008-2026 rcjaz.ca All rights reserved