GTXE 2027 Front Central Dogbone Drive Shaft 80mm - XRAY 355434-XH  [XR-355434-XH]

This 80mm front central dogbone drive shaft is a direct replacement engineered for the GTXE 2027 platform. CNC-machined from Hudy Spring Steel and hardened for improved wear resistance, the part has material removed where safe to reduce mass while keeping strength to handle typical touring car driveline loads.

Each shaft is hand-ground for dimensional accuracy and is individually measured and inspected to control runout and ensure consistent fitment. HUDY special hardened pins are used for retention to provide predictable service life under normal RC use.

With reduced rotating mass and accurate machining, the component can lower front driveline inertia, which affects throttle response and balance. During fitment, verify correct pin engagement, confirm clearance to steering and suspension parts, and check that front shaft lengths match to avoid drivetrain binding.