GT Front Anti-roll Bar Bulkhead Right for Flat Chassis - XRAY 352018  [XR-352018]

Right-side front anti-roll bar bulkhead overview

This right-side front anti-roll bar bulkhead is designed for GT flat chassis layouts where precise anti-roll bar motion and predictable front-end stiffness are required. The component locates and supports the anti-roll bar bearings to maintain consistent motion under repeated loading typical in competitive RC track use.

Machined from Swiss 7075 T6 aluminum, the bulkhead is produced to tight tolerances to ensure a repeatable fit and a solid interface with the chassis. Key bearing zones are reinforced to limit deformation and preserve anti-roll bar geometry during demanding sessions, helping roll response remain consistent lap after lap.

Install the part on the right side of the front assembly and secure it using the chassis' existing mounting points. Because the bulkhead forms part of the front structure and alters the anti-roll bar's effective leverage, consider it within the overall ride and balance setup rather than as an isolated tuning tweak.

Choose this right-side bulkhead when a rigid, accurately located support for the front anti-roll bar is required on GT flat chassis designs; it is intended to provide repeatable behaviour and long-term dimensional stability for RC race tuning.