This set includes four 1.0 inch adhesive crawler tires built for TRX4M scale platforms. Molded from butyl rubber in a super-soft compound, the tires come with standard foam inserts and internal reinforcement to resist tear and support loads during slow-speed crawling. Dimensions are 56mm outer diameter by 19.5mm width to match 1.0 inch wheel mounts used on the listed TRAXXAS 1/18 chassis.
Installation relies on a snug inner diameter and a longer clamping tongue to reduce slip on bead-style wheels. The package uses a longer fixing screw and a narrow clamp thickness so the tire can be secured directly to compatible bead wheels. The included foam insert helps stabilize the tread under low-speed loads, and the reinforced carcass is intended to last longer than simple plastic-style tires.
Tuning advice: pick foam density to trade sidewall support against compliance for traction; firmer inserts hold obstacles better, softer inserts increase surface contact on rough terrain. Check adhesive bonds and inspect for cuts after hard runs, replacing inserts if they lose form or compress excessively.
Copyright © 2008-2026 rcjaz.ca All rights reserved
