GPM TRAXXAS X-Maxx +1mm Aluminium Wheel Hex Claw TXM006/+1 - RC Spare Part  [TXM006/+1]

Aluminium wheel hex for X-Maxx tuning

This aluminium wheel hex claw fits TRAXXAS 1/8 X-Maxx applications and is supplied as a pair. It provides a +1mm offset to modify wheel engagement and is offered as a direct replacement designed to mate with standard X-Maxx hub assemblies while keeping the upgrade focused on wheel position and clamp stability.

Fit these claws when a slight outward shift helps clear tyre rub, improves seating with aftermarket rims, or lets you dial a small change in track width for handling balance. The aluminium build gives better dimensional stability and wear resistance than common plastic hexes, helping keep stable wheel mounting under load.

Installation uses the usual wheel removal and refit routine: remove the wheel and original hex, install the aluminium claw onto the hub, check for flush seating, then refit and secure the wheel to factory torque. After fitting, inspect wheel runout and retention during a short low-speed test run before normal use.

For builders and tuners running TRAXXAS X-Maxx, this +1mm aluminium hex claw gives a compact option to adjust wheel fit and improve durability without changing hub assemblies, making it useful for wheelset upgrades and fitment checks.