GPM TRAXXAS MAXX Front/Rear Adjustable CVD Drive Shaft Kit TXMS143F/RS - RC Spare Part  [TXMS143F/RS]

CVD driveline kit summary

This replacement driveline is made for TRAXXAS MAXX setups fitted with +20mm widening hubs. The assembly swaps the stock cross-head output for adjustable CVD swing joints to deliver more direct power to the wheels while keeping mass low through a 6061 T6 aluminum centre housing paired with hardened steel joint internals.

The rebuild ups axle diameter from 6mm to 8mm for greater torsional resistance, and the telescopic length adjustment helps retain correct suspension geometry after widening. Bearings have been revised for the larger axle and the required 8x16x5 bearings are included to match the new shaft dimensions.

Practical role: the kit transmits gearbox torque to the wheels, supports a +20mm track width increase and permits fine tuning of drive length to restore wheel alignment and stance.

For TRAXXAS MAXX owners using a +20mm widening conversion who want a stiffer, adjustable front and rear driveline, this kit supplies hardened steel CVD joints and an aluminum centre section with a beefier 8mm axle; confirm bearing fit and check suspension travel during setup before first run.