GPM TRAXXAS 1/10 Slash 4x4 Front CVD Drive Shaft SSLA1280FH - RC Spare Part  [SSLA1280FH]

Slash 4x4 front CVD upgrade

This front CVD drive shaft is an aftermarket replacement part made for TRAXXAS 1/10 Slash 4x4 scale models. It pairs steel and aluminium components to keep strength where needed while lowering rotating mass, and it is intended for scale RC use only. The shaft is shaped to mate with the Slash 4x4 front axle assembly without implying any road vehicle application.

The CVD head and 12mmx6mm wheel hex have been revised from prior designs to improve retention at the hub interface, and the assembly includes an adjustable length section to help fit varying front-end geometry. Those choices make it a straightforward direct-fit option for drivers who want a tougher front driveline that still fits common Slash 4x4 setups.

Installation notes: the shaft is a direct replacement designed to slide over the existing crosspins and into the hubs used on Slash 4x4 front ends. Check pin seating, confirm hex tightness, and verify axle alignment during fitment. Use the correct hex drivers and secure the wheel hex before running the truck.

For builders focused on front-end driveline durability and tighter hub retention, this replacement offers a practical upgrade path for Slash 4x4 trucks and remains simple to install and tune.