GPM TMP75042 Kyosho Inferno MP7.5 Titanium Cap Joint Front & Rear Gearbox  [TMP75042]

Kyosho Inferno MP 7.5 Option Titanium Cap Joint For Front + Rear Gear Box - 2pcs - GPM TMP75042
Price:
CAD$17.71
Brand:
GPM
Model:
TMP75042
Please kindly input your name and email address, we will inform you once we have the restocking.
Or you may find similar product under the
category
Write a review

MP7.5 gearbox titanium cap joint

This titanium cap joint is a direct replacement for the Kyosho Inferno MP7.5 front and rear gearbox locations. Supplied as 2 pcs, it sits between the driveshaft and gearbox cap to keep alignment and transfer torque reliably through the model drivetrain.

Fitting is straightforward for anyone used to gearbox service: remove the gearbox cover, extract the original cap joint, position the titanium unit in the correct orientation, then reassemble while checking gear mesh and bearing alignment. Use the correct hex drivers and a tidy workspace to avoid over-tightening fasteners.

As a focused hop-up this part replaces the stock cap joint with a titanium option aimed at improved durability and consistent joint geometry for race-day setups or club track running. It is intended to stabilise drivetrain behaviour during setup changes rather than change suspension or motor characteristics.

Will this fit both front and rear gearbox positions on the MP7.5?

Yes, the design matches the front and rear cap joint locations specified for the Kyosho Inferno MP7.5, so the same part is used in both positions.

What basic tools do I need to install it?

A set of hex drivers, a clean bench, and a light thread locker for fasteners if required. Check gear mesh and bearing alignment during reassembly to avoid binding.

Will this affect handling or motor performance?

No direct change to suspension or motor output is expected; the cap joint focuses on drivetrain reliability and repeatable alignment under load.

Copyright © 2008-2026 rcjaz.ca All rights reserved