This alloy front rim is an RC-scale replacement made for Team Associated RC18T platforms, intended to restore or adjust front wheel contact geometry when a concave sinkage surface is required. The profile is designed for repeatable fitment to RC18T front hubs and to give a durable mounting face for common short-course tyres.
The rim follows the original RC18T front wheel mounting pattern and uses an alloy body for consistent stiffness and improved wear resistance over standard plastic rims. It is suitable for routine hobby maintenance, race-prep swap-outs, and bench tuning where front-end sink characteristics are changed to influence handling.
Installation is straightforward for those familiar with RC wheel removal: remove the wheel assembly, align the rim with the hub mounting holes, then secure using the original hardware. No special tools are needed beyond standard hex drivers. This is an accessory for 1/18 scale RC models only and is not intended for real vehicle use.
Copyright © 2008-2026 rcjaz.ca All rights reserved
