GPM Tamiya DF-02 Rear Adjustable Alloy Spring Damper 100mm DF23100 - RC Spare Part  [DF23100]

Tamiya DF-02 Alloy Rear Adjustable Spring Damper (100mm) With Alloy Collars & Screws & Plastic Black Dust Proof & Lock Nuts - 1pr set - GPM DF23100
Price:
CAD$33.01
Brand:
GPM
Model:
DF23100
GTIN:
4894538041019
Condition:
Brand New
Write a review

Adjustable rear shock for DF-02 tuning

This aftermarket rear spring damper is made for the Tamiya DF-02 platform and supplied as a 1 pr set. The assembly includes alloy collars and matching alloy screws, black plastic dust seals and lock nuts, and a nominal 100mm length intended for rear suspension fitment on DF-02 chassis arrangements.

In use the unit gives collar-based spring preload adjustment and mechanical locking with the supplied nuts, making it a direct rear shock replacement where the mount points and stroke correspond to DF-02 geometry. The plastic dust seals reduce grit ingress around the piston area, while the alloy collars and screws give robust clamping for frequent setup changes.

Specifications

  • Item: Rear adjustable spring damper, 1 pr set
  • Material: Alloy collars and screws, plastic dust seals
  • Model Number: DF23100
  • Compatibility: Tamiya DF-02
  • Length: 100mm

Fit this 100mm rear damper to DF-02 cars that require rear shocks of this length, then pair with suitable springs and adjust collars to dial in ride height and preload for street or light off-road running.

Can I swap these into my DF-02 without modding the mounts?

If your DF-02 uses 100mm rear shock spacing and the same clevis or eyelet style, these should install as a direct replacement; always verify mount spacing before fitting.

Are the alloy collars reusable for frequent setup changes?

Yes, the alloy collars and screws are durable for regular preload adjustments, but check threads and tighten lock nuts to prevent slippage after repeated use.

Do these dampers come pre-filled with oil?

These are mechanical spring dampers with collar preload and do not rely on a factory oil fill; treat them as spring-and-shock assemblies intended for standard DF-02 layouts.

How should I maintain the dust seals?

Keep the seals free of grit by wiping after runs, inspect for tears or compression, and replace seals when they show wear to maintain consistent action.

Copyright © 2008-2026 rcjaz.ca All rights reserved