GPM SCX30/2830 7075-T6 Flex Blade Extensions for 1/30 SCX30 - CNC aluminium upgrade  [SCX30/2830]

CNC aluminium flex blade extensions for 1/30 SCX30 crawlers

This set of four flex blade extensions is CNC machined from 7075-T6 aluminium for use on AXIAL 1/30 SCX30 series rock crawlers. The parts act as droop extensions to increase suspension droop and produce a slightly lower static ride height. Fit them as a tuning option to alter axle articulation and reduce low speed roll for tighter line control.

Compatibility and expected effects

The pieces are shaped as RC suspension extensions made to work with the listed AXIAL SCX30 truck variants. Once fitted they provide more droop travel compared to common stock plastic blades and lower the ride height a small amount. That change affects link geometry, so steering feel and weight transfer may shift; perform measured tests and adjust vehicle setup after installation.

Fitment and setup checklist

• Set of 4 pieces supplied for front and rear mounting.
• These parts replace or attach at existing flex blade locations—confirm orientation and fastener fit before final torque.
• After fitting, cycle full suspension travel and steering lock to confirm clearance; recheck hardware after initial runs.
• Use a stepwise tuning approach: change one variable at a time (blade length, shock tune, weight) to evaluate handling.