GPM MZA503F/R/+3.5 KYOSHO Mini-Z AWD Alloy Sinkage Rims 3.5mm Offset  [MZA503F/R/+3.5]

Mini-z AWD Alloy Front/Rear Sinkage Rims (5p, 3.5mm Off set , Width 8.5mm) - 1pr - GPM MZA503F/R/+3.5
Price:
CAD$8.12
Brand:
GPM
Model:
MZA503F/R/+3.5
Please kindly input your name and email address, we will inform you once we have the restocking.
Or you may find similar product under the
category
Write a review

Mini-Z AWD Wheel Upgrade Overview

This set of alloy sinkage rims is made for KYOSHO Mini-Z AWD platforms as a direct wheel upgrade for scale RC use. The layout is optimised for wheel fit and clearance control so you can adjust track clearance and tyre seating without altering hub or driveshaft geometry.

Key details are captured in the product name: a 5p bolt pattern, 3.5mm offset and an 8.5mm nominal width, all in an aluminium alloy build. Use these rims to change scrubbing behaviour, correct stance, or swap tyre profiles; they are compatible with standard Mini-Z AWD wheel nuts and common hex adapters used on MR-03 AWD style setups.

Installation notes: remove the existing wheel, check hex adapter alignment and surrounding clearance, then fit the rim and hand-tighten the wheel nut before a final torque pass. After mounting, roll the car to confirm tyre seating and steering range, and inspect for rubbing at full lock.

Will these rims fit MR-03 AWD hubs?

They are made for Mini-Z AWD platforms that use MR-03 style hex adapters, but you should verify hex size and hub spacing on your car before final fitment.

Can I run foam or rubber inserts with these rims?

Yes, common Mini-Z foam and rubber inserts fit these rims; check tyre wall thickness and seating depth when changing insert types to avoid bulging or poor adhesion.

Any tips to prevent tyre rub after installation?

Trim inner wheel wells if needed, confirm body mount clearance, and test steering lock while the car is on stands to ensure full range without contact.

Copyright © 2008-2026 rcjaz.ca All rights reserved