GPM MT/ST HPI Bullet 3.0 Front Tire and Beadlock Rim Set BMT1003F+889  [BMT1003F+889]

Front tire and beadlock kit for HPI Bullet 3.0 MT/ST

This aftermarket set supplies rubber front tires fitted to nylon rim frames with alloy 10-pole beadlock rings and includes 12x9mm drive adapters for use with HPI Bullet 3.0 MT and ST nitro chassis. The kit is sized as an RC-scale replacement to recover steering feel and allow simple front-end setup changes without altering the original hub geometry.

Installation is straightforward: remove the stock front wheels, fit the 12x9mm drive adapters to the existing hex or axle interface, seat the tire on the nylon rim, then fasten the alloy beadlock ring with the supplied hardware. Confirm adapter fit before running.

For setup work, the rubber compound and beadlock clamp let you tweak seating and small stagger adjustments while keeping a robust rim structure. Nylon frames help limit impact damage and the alloy 10-pole beadlocks keep the tyre secured for consistent steering on mixed surfaces. Inspect beadlock screws and adapter tightness after initial runs.

Use this set to replace worn front tyres or to experiment with minor front-end setup changes on HPI Bullet 3.0 MT/ST nitro models; keep beadlock screws checked and avoid over-tightening the adapters to protect hexes and axles.