GPM GSAV1049 HPI Savage 21 Graphite Steering Plate  [GSAV1049]

Low-profile graphite steering plate for Savage 21

A single-piece aftermarket graphite steering plate made for HPI Savage 21 RC models, supplied as a 1 pcs set with the screws needed for installation. It replaces compatible stock plates to give a firmer mounting surface that improves steering feedback while keeping the original steering geometry intact.

Fitting is simple for hobbyists familiar with basic chassis work: remove the factory plate, secure the graphite unit using the supplied screws, set the steering linkages to neutral and check the full travel for any binding. Standard hex drivers are sufficient; always verify screw fit and thread engagement before final torque.

In setup terms this plate is used to alter front-end stiffness and steering response; swapping between stock and graphite plates is a common way to fine-tune how the vehicle reacts to servo input and track conditions. This accessory is intended for routine maintenance and small tuning changes rather than major chassis modification.