GPM DMZA601RW+1.0 KYOSHO Mini-Z AWD Rear Wide Delrin Ridge Rim  [DMZA601RW+1.0]

Mini-z AWD Delrin Rear Wide Ridge Rims (6p, 1.0mm Off set , Width 11mm) - 1pr - GPM DMZA601RW+1.0
Price:
CAD$9.56
Brand:
GPM
Model:
DMZA601RW+1.0
Please kindly input your name and email address, we will inform you once we have the restocking.
Or you may find similar product under the
category
Write a review

Delrin rear wide rims for Mini-Z AWD

This rear-scale wheel is produced for KYOSHO Mini-Z AWD platforms and identified as model DMZA601RW+1.0. The rim is formed from Delrin and uses a six-point mounting pattern, with a 1.0mm offset and an 11mm rim width to suit Mini-Z AWD wheel geometry.

Fitting is straightforward for those familiar with Mini-Z maintenance: remove the stock rear wheel, check hub alignment with the six-point interface, and refit using the original fasteners. After installation, confirm tyre seating and body clearance to prevent contact with suspension components or body mounts.

From a setup perspective, this rear wide ridge rim changes rear track and contact patch behaviour, making it useful for adjusting balance and rear grip on carpet or small club circuits. Make tuning adjustments incrementally while keeping tyre and chassis variables consistent.

Which Mini-Z AWD chassis will accept this rim?

It is intended for KYOSHO Mini-Z AWD cars that use a six-point rear hub pattern, including MR-03 AWD family variants. Always verify hub pattern and axle spacing before fitting.

Will standard Mini-Z tyres fit an 11mm rim?

Most Mini-Z tyres that list compatibility with 11mm rims will mount correctly, but check tyre bead seating and overall diameter so the tyre does not foul the body or suspension.

How does the 1.0mm offset affect handling?

The 1.0mm offset slightly widens rear track and alters the contact patch; expect changes in rear-end grip and stability. Test changes gradually and record settings for repeatable results.

Copyright © 2008-2026 rcjaz.ca All rights reserved