GPM BUGW0105/G KYOSHO Hyper 7 / RC8 1/8 Buggy Nylon 5-Pole Wheel  [BUGW0105/G]

5-pole nylon wheel for 1/8 buggies

This wheel (model BUGW0105/G) is offered as a direct aftermarket replacement for KYOSHO Hyper 7 and RC8 1/8 buggy platforms. Fabricated in nylon with a five-pole spoke layout, the wheel is sized to fit common 1/8-scale buggy hubs and is suitable for hobbyists replacing worn parts or tuning wheel flex characteristics.

The component purpose is simple: swap a damaged wheel, restore correct mounting geometry, or use the alternate spoke pattern to slightly alter lateral flex and handling under setup changes. Installation follows the same basic steps used across most 1/8 buggies — remove the wheel nut, fit the replacement, and torque the nut to the chassis maker's recommended value while checking hub alignment.

Supplied as 1 pr, the wheel gives a matched left/right set for a single axle. Confirm hub hex size and mounting method on your Hyper 7 or RC8 before fitting, and use threadlocker or the original wheel nuts where applicable to secure the assembly.