This two-piece stainless steel skid plate set is an accurate-scale accessory created to shield the underside of both the front and rear gearboxes on Axial SCX6-based crawlers. The plates mount close to the gearbox base to block sand, gravel and small impacts commonly encountered on trails and in scale sessions.
The material selection prioritizes corrosion resistance and abrasion protection. Stainless steel provides a tougher contact surface than typical plastics and stands up better to wet or gritty conditions, reducing wear from repeated debris strikes.
Fitting is straightforward: the plates are contoured to the gearbox base and attach to the vehicle's existing mounting points, keeping a low profile so suspension geometry and drivetrain alignment remain unchanged. These plates are intended as protection, not as substitutes for gearbox repair.
Fit these skid plates for sandy, rocky or damp running where debris and moisture increase wear, or when you want a durable underside shield during frequent practice or competitive scale crawling.
Copyright © 2008-2026 rcjaz.ca All rights reserved
