GPM AXIAL SCX10 III Rear Bumper Mount 6061 T6 Aluminium SCX3331R Pack  [SCX3331R]

6061 T6 rear bumper mount for SCX10 III

This aluminium rear bumper mount is built for the AXIAL SCX10 III JEEP WRANGLER platform and is listed as part number SCX3331R. The component combines a CNC-style 6061 T6 machined body with the supplied mounting hardware to secure the rear bumper and increase mounting stiffness on scale RC rigs.

The mount uses a hollowed, 3D cut profile to cut weight while keeping load paths rigid at screw points. It is intended to improve chassis-to-bumper load transfer during trail use and minor scale impacts, not to take the place of full-size hardware. Supplied fasteners allow a direct replacement or an upgrade over the stock plastic mount.

Before fitting, check bumper clearance and rear body mount space on your SCX10 III Wrangler replica. The aluminium mount alters how forces travel into the rear chassis, so re-torque the screws after initial runs and confirm the bumper lines up with the chassis rails.

Fit this aluminium rear bumper mount to replace or upgrade the stock rear mount on an AXIAL SCX10 III Wrangler scale chassis to gain firmer mounting and more durable hardware for trail and scale running.