GPM Axial SCX10 II 27mm Aluminium Wheel Hex Adapters SCX2010/275 [SCX2010/275]

AXIAL Racing SCX10 II Aluminium Wheel Hex Adapters 27mm Width (Use For 4mm Thread Wheel Shaft & 5mm Hole Wheel) - 1pr set - GPM SCX2010/275

Price:

CAD$9.53

Brand:

GPM

Model:

SCX2010/275

GTIN:

4894538252859

Condition:

Brand New

Color Available:

Quantity:

Write a review

alt="AXIAL Racing SCX10 II Aluminium Wheel Hex Adapters 27mm Width (Use For 4mm Thread Wheel Shaft & 5mm Hole Wheel) - 1pr set - GPM SCX2010/275" title="AXIAL Racing SCX10 II Aluminium Wheel Hex Adapters 27mm Width (Use For 4mm Thread Wheel Shaft & 5mm Hole Wheel) - 1pr set - GPM SCX2010/275"

Description
FAQ

27mm aluminium hex adapters for SCX10 II

This pair of aluminium wheel hex adapters gives a 27mm overall width to widen track and boost lateral stability on scale crawlers and trail rigs. They are compatible with AXIAL Racing SCX10 II and let you run wider wheel spacing without changing hubs or axle geometry.

Each adaptor accepts wheels with a 5mm centre hole and mounts to a 4mm threaded wheel shaft, so fit depends on matching those dimensions. The internal hex uses a Delrin locating collar to reduce axial play and keep the tyre and wheel seated under high traction loads common in crawling.

The hardware layout secures the hex reliably: one side uses an O-ring for preload, the other side uses a spring-steel retaining ring, a spring with washers, and a stainless screw to clamp the assembly. These components allow fine adjustment of retention so the wheel stays tight without binding bearing surfaces.

In use the adapters widen the wheel stance for better cornering and stability on rock gardens and technical trails, and help prevent unwanted wheel spin when a tyre loses grip. Installation is straightforward for hobby-level maintenance using standard hex drivers and basic hand tools.

This item is compatible with

AXIAL SCX10 II
AXIAL SCX10 II 90047

How do I check if my wheels will fit these adapters?

Measure the wheel centre hole and the threaded shaft on your rig. These adapters require a 5mm wheel centre hole and a 4mm threaded wheel shaft for correct fitment.

Can I adjust retention to avoid bearing binding?

Yes. The assembly uses an O-ring, retaining ring, spring and washers with a stainless screw so you can tune preload to hold the wheel without loading the bearings.