This 8pcs rod link set is an RC-scale replacement built for the AXIAL SCX-10 II chassis, intended for front and rear linkage positions on the Jeep Cherokee layout. The kit combines aluminium shafts with plastic ball ends as noted in the title, and is configured for a 330mm wheelbase.
Fit this set to replace worn factory links or to tune roll centre and steering geometry during a scale crawler setup. The plastic ball ends help reduce binding when used with standard threaded rod adaptors, while the aluminium shafts keep links straight and stiffer than stock plastic pieces.
Installation tips: confirm the 330mm wheelbase before fitting, reuse compatible original hardware when possible, and check linkage lengths and end orientations against your vehicle build to preserve suspension and steering characteristics.
For scale crawler enthusiasts running an AXIAL SCX-10 II Jeep Cherokee with a 330mm wheelbase, this 8pcs aluminium rod link pack provides a direct-fit replacement that focuses on simple serviceability and steady linkage behaviour.
Copyright © 2008-2026 rcjaz.ca All rights reserved