GPM AXIAL CAPRA 1.9 Brass front and rear gearbox cover CP012AX Pack  [CP012AX]

Brass gearbox cover set for CAPRA 1.9 UNLIMITED

This 5pcs RC-scale brass front and rear gearbox cover set is made for the AXIAL CAPRA 1.9 UNLIMITED chassis. The precision-machined brass plates come with stainless steel cap head screws and are designed to shield the front and rear gearbox housings while adding rotational weight to help stabilise the diffs during slow, technical trail driving.

The covers are cast and machined from brass with a total kit assembly weight of 67 grams as listed in the source. That deliberate mass bias helps tune traction and balance on scale trail rigs without changing internal gears. Fitment is intended specifically for the AXIAL CAPRA 1.9 UNLIMITED chassis; treat this as an aftermarket accessory when adjusting suspension or driveline settings.

Fitting involves removing the stock gearbox cover and reusing or replacing seals if needed. Use the supplied 2.5x16 stainless steel cap head screws and tighten to standard small-scale RC torque to avoid thread damage or misalignment, then rotate the differential by hand to confirm correct gear mesh and bearing alignment.

Choose this brass cover when you need a tougher gearbox face and a small increase in rotational mass for improved low-speed diff stability on an AXIAL CAPRA 1.9 UNLIMITED; confirm screw torque and gear mesh after installation and monitor differential behaviour on initial runs.