GPM Associated RC 18T Titanium Hinge Pin Pack - TAR101  [TAR101]

Precision titanium pins for 18T use

The TAR101 hinge pin set fits Associated RC 18T models and is supplied as four pairs for full pivot replacement. These titanium pins replace standard items to give reduced weight with improved corrosion resistance and long-term service suitable for 1/18 off-road buggies. The paragraph explains fit, simple installation steps and how the pins help control pivot play and suspension geometry.

Fit and role: These hinge pins are made to match Associated RC 18T mounting points, acting as the pivot for front or rear hubs depending on chassis layout. They are commonly fitted during routine servicing when worn pins are replaced and when setup changes require consistent pivot geometry for handling and alignment.

Installation notes: Follow standard hinge pin service procedures. Clean the pivot area, remove any retaining clips or e-clips, slide the old pins out and inspect hub bores for wear before fitting the new pins. Reinstall the retainers and confirm the suspension moves freely through its full travel. Use thread-lock only on fasteners that call for it; the pins do not need adhesive.

Workshop tuning pointers

• Inspect hub bores before fitting new pins to prevent early slop.
• Lightly lubricate mating surfaces after assembly to reduce binding and corrosion.
• Check toe and camber after replacement because small changes in pivot seating can alter alignment.