Gmade R1 Front and Rear CVD Drive Shafts Spring Steel - GM239SF/R by GPM  [GM239SF/R]

Front and Rear CVD Shafts for the Gmade 1/10 R1

This 1/10-scale replacement set is made for the Gmade 1/10 R1 Rock Buggy platform and is supplied as one front and one rear CVD drive shaft. The shafts are manufactured from spring steel as listed in the product identifier and are intended for routine drivetrain service, repair, or parts replacement on rock buggy rigs.

Fit these CVD shafts to restore correct spline engagement when original parts show wear, or to return a buggy to reliable operation after maintenance. Confirm spline alignment at the differential and hub, secure retaining hardware, and check for free movement through steering and suspension travel to prevent binding.

Consider these shafts a direct replacement drivetrain component rather than a power upgrade; inspect regularly for play at CV cups, signs of wear, or bent shafts and replace as required to preserve predictable drivetrain behaviour during off-road and rock-crawling runs.

This front and rear pair is intended as a functional replacement for the CVD shafts used on Gmade R1 rock buggies and helps maintain drivetrain integrity and consistent handling while crawling or running off-road.