GF01/TL01 38mm Hard Steel Front and Rear CVD Shafts - GF1238C by GPM  [GF1238C]

Metal CVD shaft upgrade for GF01 and TL01

This CVD shaft pair is an aftermarket replacement for Tamiya GF01 platforms and TL01 conversion builds. The two shafts fit as front and rear half-shafts when the axle layout uses 38mm centre-to-centre lengths, letting you swap out worn hollow or plastic driveline parts for metal components.

The parts use aluminium for mounting interfaces and hardened steel for the driven surfaces, aimed at increasing driveline service life rather than changing suspension geometry or ride characteristics. Basic removal of hub carriers and common half-shaft retainers is required for fitment.

Installation notes: confirm overall stroke and outboard cup clearance prior to final assembly, check hexes and pins for wear, and ensure the set meets the 38mm centre-to-centre requirement for your axle layout. Use thread locker on mating fasteners where the original design specifies it, and verify there is no binding through full suspension travel.

Select this set to replace aged plastic half-shafts or for routine maintenance when you prefer metal front and rear CVD shafts while keeping the vehicle within intended 1/10 scale driveline geometry.