GF01 Steel Steering Tie Rod with Integrated Servo Horn - GF160STM by GPM  [GF160STM]

GF01 steel steering link set

This 2pcs set is an aftermarket steering link assembly made for the Tamiya GF01 platform, pairing a spring steel tie rod with an integrated servo horn to replace fragile plastic components. It is a scale RC upgrade meant to increase steering linkage stiffness and lower the risk of thread damage during normal hobby use.

Installation is simple for anyone familiar with GF01 upkeep: remove the factory linkage, mount the steel tie rods between the steering knuckles and the servo output, and reuse original fasteners where they fit. Verify final wheel alignment with the vehicle on the ground and steering centred before torquing hardware to prevent binding.

From a tuning perspective this upgrade helps deliver crisper steering feedback and less slop between servo and knuckles; check toe settings and recalibrate servo endpoints after fitting instead of altering the linkage geometry unless you intend to change steering behaviour.