Futaba S30G S130G Retract Servo Gear Set - FUSG130G  [FUSG130G]

Replacement Gears for Retract Servos

This gear set is a direct replacement accessory intended for Futaba S30G and S130G retract servos used in RC scale models. It addresses the mechanical gear components that transfer torque inside retract-type servos, offering a like-for-like swap when original gears wear or develop play.

Installation is straightforward for technicians experienced with hobby servos: remove the servo horn and case, inspect the existing gear train alignment, replace the worn gear or gears with the replacement parts, and verify free rotation before reassembling. Pay attention to tooth mesh and shaft seating to avoid binding during reinstallation.

For tuning and maintenance, clean the gear train, inspect bearings and shaft runout, and apply a light, appropriate lubricant to the gear teeth only. Replacing worn gears can restore repeatable retract motion and reduce slop that impacts retraction timing and landing sequence consistency.