Futaba FUNR7003SB 3-Channel S.BUS2 FASSTest HV Telemetry Full-Range Receiver  [FUNR7003SB]

FUTABA R7003SB 2.4GHZ 3-CHANNEL S.BUS2 FASSTEST TELEMETRY HV FULL RANGE RECEIVER
Price:
CAD$75.33
Brand:
Futaba
Model:
FUNR7003SB
Condition:
Brand New
Write a review
alt="FUTABA R7003SB 2.4GHZ 3-CHANNEL S.BUS2 FASSTEST TELEMETRY HV FULL RANGE RECEIVER" title="FUTABA R7003SB 2.4GHZ 3-CHANNEL S.BUS2 FASSTEST TELEMETRY HV FULL RANGE RECEIVER"

Compact Full-Range 3-Channel Receiver

The Futaba FUNR7003SB delivers reliable full-range reception in a small footprint, built to work with S.BUS2 peripherals and FASSTest transmitters for telemetry-capable installations. It is intended to provide consistent signal link quality while passing telemetry information back to the transmitter.

In typical use the receiver acts as the central node for S.BUS2 servos and compatible sensors. Installation priorities include tidy antenna routing, firm S.BUS2 connector seating, and placing the receiver to preserve an unobstructed signal path for best performance.

For setup and tuning treat the FUNR7003SB as the telemetry endpoint: complete binding with a FASSTest-capable transmitter, enable telemetry pages on the transmitter if required, and verify S.BUS2 device addresses when multiple devices share the bus. The HV marking denotes support for higher-voltage servo rails when the connected servos and power supply meet the same specifications.

Specifications

  • Item Receiver
  • Material Electronic components
  • Model Number FUNR7003SB
  • Compatibility FASSTest 2.4GHz systems, S.BUS2 devices

As a compact S.BUS2 and telemetry-capable 3-channel receiver, the FUNR7003SB is suitable where compact size, full-range reception, and telemetry integration are required within Futaba FASSTest systems.

How do I bind the FUNR7003SB to a FASSTest radio?

Put the receiver into bind mode and use the bind function on your FASSTest transmitter. Ensure the receiver has power and follow the transmitter prompts until binding completes.

What advantages does S.BUS2 provide on this receiver?

S.BUS2 lets multiple digital servos and sensors share a single bus for channel data and telemetry, which reduces wiring complexity and enables extended telemetry features on supported transmitters.

Is the HV rating necessary for my servos?

The HV label means the receiver supports higher-voltage servo setups. Confirm your servos and power source match the recommended voltage range before connecting.

How can I confirm telemetry is being received by the transmitter?

Enable telemetry in the transmitter menus and view telemetry pages or alerts. Check for live sensor values and verify each S.BUS2 device ID if needed to confirm data flow.

Copyright © 2008-2026 rcjaz.ca All rights reserved