Futaba FUAS3206 Replacement Metal Gear Kit for S3003 Servos - EBS3206 AS3206  [FUAS3206]

FUTABA S3003 SERVO GEAR SET EBS3206 AS3206
Price:
CAD$5.28
Brand:
Futaba
Model:
FUAS3206
GTIN:
4513886301285
Condition:
Brand New
Write a review

Internal gears for S3003 servo repair

This gear set is an RC replacement designed for Futaba S3003 servos and supplies metal internal gears to restore worn or broken components. It lets model builders refresh the servo drive train without having to replace the entire unit, addressing issues like stripped teeth or intermittent slipping.

Installation notes: remove the servo cover following the S3003 disassembly method, extract the damaged gear stack and fit the replacement gears in the same order and orientation. Adjust gear mesh and check axial play prior to closing the case to prevent binding or excessive friction.

Tuning role: fitting new metal gears helps reclaim repeatability and reduce play that compromises steering accuracy. Once installed, confirm neutral position and run a full-range bench test before reinstalling the servo in the model.

Does this fit only the S3003, or other Futaba micro servos too?

This kit is produced specifically for the internal gear stack used in S3003 servos and is intended as a direct replacement for that model. Fitment with other Futaba servos is not guaranteed without checking spline and gear dimensions.

What basic tools are recommended to change the gears?

Simple hand tools are sufficient: small Phillips or flat screwdrivers, tweezers or needle-nose pliers, and a clean tray to keep screws and shims organized during disassembly.

After installation, what checks should I perform?

Verify smooth rotation through the full travel, ensure correct mesh with the output spline, confirm neutral centering, and check for any binding before reinstalling the servo in the model.

Copyright © 2008-2026 rcjaz.ca All rights reserved