This DC input clip lead connector mates to the Futaba CR2000 charger DC input and gives a removable clip-style connection for batteries and power packs. It is intended for routine bench charging and testing on RC models where a quick clip hookup is useful.
Fitting is simple: attach the clips to the battery terminals and plug the other end into the CR2000 DC input. Check polarity before applying charge and keep the clips stable to avoid intermittent contact. The cable is designed for typical model bench work rather than heavy industrial or vehicle power systems.
On the bench this lead helps with battery setup and quick checks, allowing you to connect various pack types for capacity verification, balancing, or brief diagnostic runs while preparing and tuning models.
Copyright © 2008-2026 rcjaz.ca All rights reserved
