Futaba 6EXAP_c7 6-Channel PCM 35MHz Flight Transmitter with R136HP and 4x S3003  [6EXAP_c7]

Futaba 6EXAP feature summary

The Futaba 6EXAP is a six-channel RC flight transmitter bundle built to provide a ready-to-use interface for both airplane and helicopter model configurations. The radio gives direct, physical control over primary flight surfaces and engine management, with dedicated channels for flaps and retractable gear to simplify field setup without the need for custom firmware.

Channel assignments are mapped to receiver outputs as follows: channels 1, 2 and 4 handle the main flight surfaces; channel 3 is reserved for throttle; channel 5 operates retractable landing gear; and channel 6 controls flaps when a flap servo is fitted. On-board switches and rotary controls allow pilots to change dual-rate settings, tweak exponential, and use the throttle-cut for engine shutoff on the ground.

• Controls: Dual-rate switch for aileron, elevator and rudder, flap control dial assigned to channel 6, individual trim levers for each stick axis, a throttle-cut button, trainer switch and a dedicated retractable gear switch on channel 5.
• Interface: Backlit LCD display with MODE and SELECT keys, DATA INPUT lever to edit values shown, dedicated charging jack and main power on/off switch.
• Included electronics indicated in model name: The product designation references the R136HP receiver and four S3003 servos as included items.
• Antenna practice: Fully extend the antenna before flight to maximise signal range and reduce the chance of interference with nearby models.

For pilots installing a straightforward six-channel airframe or helicopter, the 6EXAP package offers a compact transmitter layout with physical controls for dual rates, flaps and gear, making field trimming and initial setup transparent and fast.