Futaba 6EXAP_c5 6-Channel FM 35MHz Airplane & Helicopter Transmitter Set  [6EXAP_c5]

Price:
CAD$207.65
Brand:
Futaba
Model:
6EXAP_c5
Please kindly input your name and email address, we will inform you once we have the restocking.
Or you may find similar product under the
category
Write a review

Field-ready six-channel FM transmitter

The Futaba 6EXAP_c5 is an RC-scale 6-channel FM transmitter package designed for pilots of both airplanes and helicopters operating on 35MHz. The bundle focuses on simple, physical control layouts and hard switches so you can adjust dual rates, trims and function dials quickly without navigating deep menus, and it comes with a receiver and standard servos to get a model airborne promptly.

Controls are organized for practical field use: an aileron/elevator dual-rate switch that also swaps exponential settings, a dedicated flap control dial assigned to channel 6, a retractable landing-gear switch on channel 5, plus a throttle/rudder stick layout with a throttle-cut button for engine shutoff procedures. Trims are included for every axis, and a DATA INPUT lever together with MODE and SELECT keys operate the LCD for programming and verification.

Installation is straightforward: mount the supplied R136F receiver in the airframe following standard placement recommendations, connect the four S3003 servos to their respective channels, fully extend and route the antenna for dependable transmission, and charge the transmitter battery via the charging jack with the included charger before first use. The trainer switch enables instructor takeover when linked to a second transmitter with a trainer cord sold separately.

Specifications

  • Item Futaba 6EXAP 6-Channel FM transmitter set
  • Material Electronic components and molded transmitter case
  • Model Number 6EXAP_c5
  • Compatibility Airplane and helicopter RC models using 35MHz receivers, includes R136F
  • Channels 6 channels with dedicated controls for flaps (ch6), gear (ch5), throttle (ch3), rudder (ch4)
  • Includes R136F receiver, 4 pcs S3003 servos, transmitter battery charger
  • Display Liquid-crystal display for programming and values

For RC pilots who want a straightforward, field-focused six-channel FM setup, the Futaba 6EXAP_c5 bundle supplies tactile switches for dual-rate and trim adjustments plus the receiver and servos needed to install and trim a sport or scale model quickly.

What items come in the Futaba 6EXAP_c5 package?

The kit includes the Futaba 6EXAP_c5 transmitter, a Futaba R136F receiver, four S3003 servos and the transmitter battery charger.

How is the dual-rate switch used on the transmitter?

Flip the dual-rate switch to alternate between two control-throw presets for aileron, elevator and rudder; use the high-rate position for full authority and the low-rate for milder response, noting that exponential settings can also change with the switch.

Which outputs operate flaps and landing gear?

The flap control dial drives the servo assigned to channel 6, while the retractable landing gear switch operates the servo on channel 5.

How do I perform a throttle-cut for engine shutdown?

Bring the throttle stick to its lowest position, then press the throttle-cut button to close the carburetor or halt engine power, following the transmitter control instructions.

Can this unit be used with an instructor transmitter?

Yes. The trainer switch provides instructor control when the transmitter is connected to a second transmitter using a trainer cord, which must be purchased separately.

What should I do about the antenna and battery before flying?

Always extend the antenna fully during operation to reduce interference and maintain range, and use the supplied charger on the transmitter charging jack to prepare the battery before your first flight.

Copyright © 2008-2026 rcjaz.ca All rights reserved