FT9 Rear Steering Hub Plate Graphite +1mm - Factory Pro O-SCP041  [FP-O-SCP041]

FT9 graphite rear steering plate

This Factory Pro aftermarket rear steering hub plate is produced for the Schumacher FT9 platform and supplied as a 1 pair replacement hop-up. The part uses graphite construction and a +1mm offset to alter rear steering geometry without changing major suspension components.

Fitment and role: the plate replaces the stock rear steering hub plate on FT9 chassis to subtly shift track/steering linkage geometry. The +1mm offset is intended for fine steering response tuning - helpful when adjusting turn-in or rear-end steering balance during setup work.

Installation notes: basic disassembly of the rear upright is required to swap the hub plates; use the original fasteners and confirm clearance through the suspension travel. Verify linkage alignment and servo endpoint settings after fitment to keep symmetric steering travel.

Tuning advice: treat this as a minor geometric adjustment rather than a major setup change, evaluate effects with short test runs, and combine with incremental tyre and toe changes for predictable results.