Front Lower Suspension Mount Aluminum 25deg for YZ-2 - Z2-300FL0A by Yokomo  [Z2-300FL0A]

Yokomo Z2-300FL0A Aluminum F Lower Suspension Mount(25?) for YZ-2
Price:
CAD$26.38
Brand:
Yokomo
Model:
Z2-300FL0A
GTIN:
0639342195671
Please kindly input your name and email address, we will inform you once we have the restocking.
Or you may find similar product under the
Spares / Hop-ups - Yokomo - Off-Road Suspension Parts category
Write a review

Front Lower Mount, Machined Aluminum

This machined aluminum front lower suspension mount fits the 2WD off-road YZ-2 chassis and replaces the factory plastic lower mount with a rigid aluminum unit. The inner suspension arm pin is produced at a 25 degree skid angle and the outer edges are chamfered for a clean appearance.

As a hobby spare part, the mount provides a firmer mounting point than stock plastic, preserves original attachment geometry, and mates with the existing suspension pins and hardware used on the compatible chassis listed below.

Installation follows the standard YZ-2 front lower mount swap: remove the front lower arm pins, fit the new mount, and reinstall original fasteners where they remain serviceable. This component is intended for model use only.

Specifications

  • Item: Front lower suspension mount (left/right fit as applicable).
  • Material: Aluminum.
  • Model Number: Z2-300FL0A.
  • Compatibility: B-YZ2T / B-YZ2CAL2 / B-YZ2DTM2 / B-YZ2DTM2S / B-YZ2DTM3 / B-YZ2CAL3.
  • Feature: Inner suspension arm pin set at 25 degree skid angle; beveled edge finish.

Select this mount when replacing worn plastic parts or when a machined aluminum option is needed for repeatable mounting points and increased durability on YZ-2 based 2WD off-road models.
Remark :
Due to limited stock availability, please notice that some Yokomo items may have to order from the factory and the ready time is around 4-6 weeks. Customer purchases the item is assumed to accept the waiting time which allows us to order directly from the manufacturer if the item is out of our warehouse.

Which YZ-2 variants will accept this front lower mount?

The compatible chassis are the listed part codes: B-YZ2T, B-YZ2CAL2, B-YZ2DTM2, B-YZ2DTM2S, B-YZ2DTM3, and B-YZ2CAL3.

Will I need special fasteners to fit this mount?

The design uses the original suspension pins and compatible fasteners for the YZ-2 variants; inspect existing hardware and replace worn pins or screws as part of the service.

Why is the 25 degree skid angle specified?

The 25 degree inner arm pin angle describes the factory orientation built into the mount. It defines the arm pin geometry and is provided so builders can match or compare setup geometry across parts and chassis.

Does the beveled finish affect fitment?

The beveled edge is primarily a cosmetic enhancement; the part is machined to the listed mounting points for direct fit on the compatible YZ-2 variants.

Copyright © 2008-2026 rcjaz.ca All rights reserved