Freya Elevator Lever Replacement HI0414130 by Hirobo  [HI0414130]

Installation Guide for the Freya Elevator Lever

This HI0414130 elevator lever is an RC-scale replacement part produced by Hirobo for the Freya series helicopter line. It serves as the mechanical link between the elevator control servo outputs and the elevator assembly, translating servo motion into collective pitch and elevator response at model scale.

Installed as a direct component within the tail/elevator control train, the lever provides predictable motion transfer and minimal play so that pilot inputs and tuning adjustments remain consistent. Fit this part when restoring worn linkages or when fine-tuning elevator response during setup flights.

Installation notes: verify the HI0414130 part number matches your Freya elevator assembly before fitting, inspect the surrounding linkage and ball bearings for wear, and adjust pushrod lengths and servo endpoints gradually during ground checks to avoid overtravel. This part is described and handled strictly as an RC accessory for hobby-grade model helicopters.