Freya Aileron Lever Replacement - Hirobo HI0414129  [HI0414129]

Freya aileron lever overview

This is an RC-scale aileron lever listed as Hirobo HI0414129, supplied as a replacement component for Eagle Freya helicopter assemblies. The paragraph below concentrates on fit, basic installation practice, and how the lever affects control feel during low-speed checks and hover tests.

Compatibility is limited to the Eagle Freya parts group as indicated by the product category, so confirm your Freya part codes before ordering. As a spare, the lever replaces a worn or damaged link arm to restore normal motion between the servo output and the control linkage.

Installation and setup notes:

• Check alignment: centre the servo horn and linkage before final tightening to avoid introducing preload that will bias controls.
• Hardware: retain the original mounting screws and any specified washers to preserve correct spacing and prevent lateral play.
• Range of motion: energize the model and verify the lever sweeps cleanly through full travel without binding or contacting nearby structures.
• Fine tuning: small adjustments to linkage length or horn position change responsiveness; make incremental tweaks and re-test hover or gentle control inputs.