FAZER Two-Way Receiver Connector for On-Road Series and Drift - Kyosho R246-8562  [KY-R246-8562]

Kyosho R246-8562 - RX 2 Way Connector
Price:
CAD$9.32
Brand:
Kyosho
Model:
KY-R246-8562
GTIN:
4548565203048
Condition:
Brand New
Quantity Discount
Unit Price You Save
2 $6.89 each $4.86 or 26%
3+ $6.20 each $9.36 or 33%
Write a review

Neat two-way receiver connector for FAZER

This Kyosho R246-8562 RX 2 Way Connector is an RC-scale receiver wiring accessory created to tidy up two-way connections on Kyosho FAZER On-Road Series and FAZER Drift models. It serves as a compact junction for receiver leads, helping to organise signal and power routing without modifying electronics or chassis parts.

Fitting is straightforward: route the receiver leads into the connector, check plug orientation, and press the connector fully home for a reliable seat. After installation, secure surplus cable to the chassis with ties or tape to reduce movement while running. This component is intended for scale electric RC cars and their internal wiring systems only.

During setup the R246-8562 reduces cable clutter and relieves strain on connector joints, which helps preserve consistent signal paths when relocating servos or ESCs during chassis adjustment. It does not alter electrical characteristics of servos, ESCs, or motors, but it makes maintenance and swaps easier at the track.
Remark :
Due to limited stock availability, please notice that some Kyosho items may have to order from the factory and the ready time is around 4-6 weeks. Customer purchases the item is assumed to accept the waiting time which allows us to order directly from the manufacturer if the item is out of our warehouse.

Which FAZER vehicles are supported by this connector?

Designed for use with FAZER On-Road Series and FAZER Drift models; check your model's receiver lead routing to confirm fit.

Can I use it to join more than two receiver leads?

The part is built as a two-way junction for tidy wiring. For combining multiple outputs, follow your receiver and servo wiring plan and avoid overloading any single connector.

How should I secure the connector to prevent disconnection?

Route cables to minimise movement, fully seat the plug, and use cable ties or tape to relieve strain on the joint while running and during transport.

Will this change my servo or ESC electrical performance?

No. It is a passive wiring junction intended for neat routing and does not alter the electrical behavior of servos, ESCs, or motors when used correctly.

Copyright © 2008-2026 rcjaz.ca All rights reserved