Fazer D2 Aluminum Turnbuckles Overview
This Kyosho FAW318 turnbuckle rod set is an RC-scale accessory built for the Fazer D2 on-road drift chassis. The kit replaces the factory plastic steering link and rear upper link rods with adjustable aluminum pieces that deliver firmer feedback and more precise trim adjustments when dialing in drift or precision driving setups.
Manufactured from A7075 aluminum and finished in red anodize, the rods resist torsional flex better than stock plastic parts, creating a more direct connection between the servo output and steering knuckles and between the rear uprights and upper link mounts. The stronger material helps the chassis respond more consistently to steering inputs under load.
Compatibility focuses on the Fazer D2 chassis. The package supplies the steering/servo rod and rear upper turnbuckles intended as direct replacements; confirm geometry and mounting positions against your Fazer D2 if the car has aftermarket modifications before installing.
Installation tips: start with hand engagement of threads, set the turnbuckles to nominal lengths, then secure fasteners to chassis torque spec; use light thread-lock on steel-to-aluminum joints where the manual suggests, and ensure rod ends articulate without binding. Make small, measured adjustments to rod length and re-evaluate toe and steering trim after each change.
Maintenance: after impacts inspect anodized surfaces for damage and replace any bent rod rather than attempting to straighten it, since bending can reduce fatigue life. Regularly check rod-end play and fastener security to keep handling consistent.
The FAW318 set gives a direct aluminum replacement for key Fazer D2 linkage points, creating a stable platform for fine steering and rear toe setup on on-road drift cars.
