FASSTest/T-FHSS SBUS2 Servo Telemetry Interface - Futaba FUSBS-01S  [FUSBS-01S]

SBUS2 Servo Telemetry Module

This SBUS2 servo telemetry sensor from Futaba passes servo feedback over the SBUS2 link to compatible Futaba systems using FASSTest or T-FHSS protocols. It connects a servo output to the receiver's telemetry bus so the transmitter can display live data for diagnostics and setup.

The unit is intended for situations where seeing servo behaviour helps when trimming or after mechanical changes. Installation is straightforward for experienced hobbyists: plug the sensor into the receiver's SBUS2/telemetry-compatible port and then configure SBUS2 telemetry in the radio following Futaba guidance.

In everyday use the sensor confirms servo communication and supports iterative tuning workflows such as adjusting end points, centring, and verifying neutral consistency before a run or flight.

Use this sensor when SBUS2 servo telemetry into a Futaba FASSTest or T-FHSS system will speed diagnostics and setup cycles in your RC models.