Factory Pro O-MCP024R Graphite Rear Upright Lever for Mugen MTC3  [FP-O-MCP024R]

Optimize Your Mugen MTC3 with a Factory Pro Graphite Upright

Replace the standard rear upright on your Mugen MTC3 with the Factory Pro Rear Upright Lever O-MCP024R, engineered in graphite to increase durability and give a steadier rear end. This upgrade targets hobbyists who want dependable on-track performance and longer service intervals from key suspension parts.

Track-Proven Fit and Balance

The graphite construction reduces rotating mass while retaining stiffness and impact resistance, helping maintain consistent handling. It is machined to match the Mugen MTC3 chassis for a precise fit and predictable feel during laps.

Graphite Advantages for Racing

Graphite provides a strong strength-to-weight balance that supports quicker responses without compromising durability. Choosing this material helps preserve chassis integrity while keeping the car responsive in corners.

Installation Tips for Best Results

• Make sure all mounting points are clean and free of grit before fitting the part.
• Tighten screws progressively and evenly to avoid bending the upright.
• Recheck alignment after the first run and retorque hardware as needed.