Factory Pro FP-O-CP0003 1mm Graphite Spur Gear Spacer - Precision Shim  [FP-O-CP0003]

Price:
CAD$11.66
Brand:
Factory Pro
Model:
FP-O-CP0003
Condition:
Brand New
Write a review

Fine tune gear mesh with a Factory Pro graphite spacer

The Factory Pro FP-O-CP0003 spur gear spacer is crafted from tough graphite to help you precisely set gear mesh on your RC. At 1mm thick this spacer gives small, reliable adjustments while keeping weight to a minimum.

Benefits of graphite spacers for RC gear trains

Graphite offers a strong yet light option for shims and spacers, making it suitable where weight and durability matter. This part helps maintain consistent mesh under load so your gears stay true during fast runs and technical driving.

Uses and compatibility with 1/10 scale setups

This 1mm spacer is aimed at hobbyists tuning spur gear spacing on 1/10 scale cars. Its simple, universal form lets it work in many on-road and off-road assemblies where a thin shim is needed to correct gear alignment.

Will this 1mm spacer fit my 1/10 touring car?

Yes, the 1mm thickness is compatible with most 1/10 scale touring cars and buggies, but check your gear stack and clearances before final assembly.

How should I set gear mesh when using this spacer?

Slide the spacer into the gear stack, then adjust pinion or spur until a small amount of play remains; use a strip of paper to get a consistent mesh feel.

Does graphite require special maintenance?

Graphite is low maintenance; just keep it free of dirt and inspect for chips or wear during routine checks, replacing if damaged.

Copyright © 2008-2026 rcjaz.ca All rights reserved