Factory Pro FP-M-ASN04BK M4 Aluminum Serrated Wheel Nut Black (8pcs) - Secure Fit  [FP-M-ASN04BK]

Price:
CAD$6.22
Brand:
Factory Pro
Model:
FP-M-ASN04BK
Condition:
Brand New
Write a review

Upgrade Wheel Security with Factory Pro FP-M-ASN04BK M4 Serrated Nuts

When wheel fastening matters, these M4 aluminum serrated nuts deliver steady performance for hobbyists. The black anodized finish and serrated edge help hold wheels firmly in place during hard runs and frequent use.

Built for Endurance and Traction

Crafted from quality aluminum, the serrated flange increases contact against the wheel surface to cut down on gradual loosening. That added bite is useful for high-speed on-road use and mixed-surface off-road sessions where vibration is common.

Fits Most 1/10 Scale Setups

These wheel nuts are sized for a wide selection of 1/10 scale RC cars and trucks, allowing simple swap-in installation. They can be tightened with standard hobby tools and integrate well with common wheel and hub assemblies.

Will these nuts work with steel and aluminum wheels?

Yes, the serrated face grips both steel and aluminum wheel faces. Take care when fitting to avoid over tightening on softer alloys.

How tight should I torque these M4 nuts?

Use moderate torque typical for M4 wheel nuts in RC use; hand-tighten then add a small, firm turn with a driver to avoid thread damage.

Do they need threadlocker for long runs?

Many users skip permanent threadlocker thanks to the serrated profile, but a removable thread compound can be used for extreme racing or long endurance events.

Copyright © 2008-2026 rcjaz.ca All rights reserved