Factory Pro FP-M-AC5010RD 5mm x 1.0t Red Collar Set 10-Pack  [FP-M-AC5010RD]

Price:
CAD$6.91
Brand:
Factory Pro
Model:
FP-M-AC5010RD
Condition:
Brand New
Write a review

Precision Red Collars from Factory Pro

The Factory Pro FP-M-AC5010RD 5mm x 1.0t collar in red is a compact spacer designed for hobbyists who need consistent alignment and spacing. This ten piece set gives you spare collars for routine maintenance or multiple adjustment points on an RC model.

Common Uses and Setup Tips

These collars work well wherever precise spacing matters, such as suspension link spacing, driveline shims, or steering geometry tweaks. With a 5mm diameter and 1.0t thickness they cover many typical RC layout needs without fuss.

Fitment and Quick Installation

The red collars fit a wide range of shafts and axles and are easy to position during assembly. Slide the collar into place and verify a snug fit; use any existing retaining hardware when required to lock the position.

Are these collars appropriate for 1/10 scale cars?

They are commonly used on 1/10 scale models but can be adapted to other scales depending on shaft diameter and the application requirements.

What is the easiest way to install a collar?

Position the collar on the shaft where you need spacing and ensure it sits flush; if your setup uses clips or grub screws use them to secure the collar after checking alignment.

Will swapping collar thickness affect handling?

Small changes in spacer thickness can alter suspension geometry or driveline alignment, so test changes incrementally and note handling differences after each change.

Copyright © 2008-2026 rcjaz.ca All rights reserved