Factory Pro FP-M-AC3005LB 3mm x 0.5t Light Blue Collars 10 Pack  [FP-M-AC3005LB]

Price:
CAD$3.59
Brand:
Factory Pro
Model:
FP-M-AC3005LB
Condition:
Brand New
Write a review

Tune Your RC with Factory Pro FP-M-AC3005LB Collars

RC hobbyists who need accurate spacing will appreciate these 3mm x 0.5t collars supplied in packs of 10. The light blue finish helps with quick visual checks while allowing precise adjustments to shafts and linkages.

Where These Collars Work Best

Use the collars to set spacing on suspension components, steering assemblies, or any rotating shaft where a consistent gap matters. Their thin profile makes them ideal for small fine-tune adjustments without adding bulk.

Model Fit and Versatility

The collars suit a wide variety of model cars and similar RC projects where 3mm shafts are used. They are handy when you are building from scratch or trimming tolerances on an existing setup.

How do I pick the correct collar thickness for my setup?

Measure the clearance you need on the shaft and choose collars that add the required spacing in small increments. The 0.5t size is useful for subtle changes.

Can I use these collars on steering linkages?

Yes, they are suitable for steering linkages where shaft spacing affects throw and geometry. Make sure the bore matches your shaft snugly.

Do the collars need threadlocker or grease?

In most cases you can fit them dry for easy adjustment. If you need a permanent fit, apply a small amount of low strength threadlocker or use a retaining clip based on your assembly.

Copyright © 2008-2026 rcjaz.ca All rights reserved