Factory Pro FP-B-CB1005(12) Ceramic Ball Bearing Kit 5x10x4mm - 12 Pack  [FP-B-CB1005(12)]

Price:
CAD$80.10
Brand:
Factory Pro
Model:
FP-B-CB1005(12)
Condition:
Brand New
Write a review

Factory Pro FP-B-CB1005(12) Ceramic Bearing Upgrade for RC

If you want to improve rolling efficiency in your RC rigs, the Factory Pro FP-B-CB1005(12) ceramic ball bearing set is a practical choice. Each bearing measures 5x10x4mm and the pack contains 12 pieces to cover multiple hubs or routine servicing.

Benefits of Ceramic Ball Bearings

Ceramic bearings typically run with lower friction and resist wear better than standard steel types. That reduced drag helps components spin more freely, which can yield steadier performance during longer runs.

Compatibility and Fit

These FP-B-CB1005(12) bearings suit many models that specify 5x10x4mm replacements. Check shaft and hub clearances before fitting to ensure a proper press or slip fit without forcing the part.

Care and Installation

Keep installation areas clean and free of grit to avoid premature wear. Apply a light compatible lubricant where recommended, and perform routine inspections to catch contamination or damage early.

Can these 5x10x4mm bearings be used in motor shafts?

They can be used where 5x10x4mm bearings are specified, but always confirm the shaft diameter and required clearance for your motor or gearbox before fitting.

What type of lube works best on ceramic bearings?

A light bearing oil or a low-viscosity synthetic lubricant is usually suitable; avoid heavy greases that add drag unless a specific application calls for them.

How should I handle the bearings during installation?

Handle bearings carefully to avoid dropping or striking them. Press them in evenly using a socket that bears on the outer race and keep contaminants away from mating surfaces.

Copyright © 2008-2026 rcjaz.ca All rights reserved