Factory Pro Aluminum 7075 Red Spacer 3x9x1.0mm (8pcs) - Precision 1/10 Spacers  [FP-M-AC3110RD]

Price:
CAD$5.39
Brand:
Factory Pro
Model:
FP-M-AC3110RD
Condition:
Brand New
Write a review

Fine Tune Your RC with Factory Pro Spacers

Factory Pro supplies a pack of eight aluminium spacers sized 3x9x1.0mm, machined from 7075 aluminium and anodized red for corrosion resistance and a clean look. These thin rings help you dial in precise clearances on linkages, shocks and drivetrain components without adding unnecessary mass.

Where to Use These Spacers

These spacers are ideal for adjusting suspension geometry, shimming bearings or correcting gear mesh. Their low weight and strong alloy construction suit hobbyists who want reliable results when tweaking 1/10 scale cars and other RC builds.

Fit and Compatibility Notes

The compact dimensions make these Factory Pro spacers broadly compatible across many RC platforms. Use them where a 3mm ID, 9mm OD and 1.0mm thickness is required to achieve smooth operation and correct alignment.

Will these fit my 1/10 touring car hubs?

Check that your hub or bearing needs a 3mm inner diameter and 9mm outer diameter spacer. Many 1/10 touring setups accept this size for shimming wheel bearings or tightening play in axles.

Are they strong enough for off road use?

7075 aluminium provides good strength for lightweight spacer duties, but heavy impact loads may still deform small thin spacers. Use them where spacing and alignment are the main requirement.

How should I install these without scratching?

Slide spacers over the shaft carefully and avoid forcing them against rough edges. Use light grease on metal-to-metal contact to reduce wear and keep components moving smoothly.

Copyright © 2008-2026 rcjaz.ca All rights reserved